The DCS4002 system consists of four key components making it the only truly plug-n-play, no power wire required installation available. Comprised of our USA made Reference Series ferrofluid speakers, DCM1 DSP module, an RS400 400-Watt Class-D amplifier and an application specific bracket, this system is everything needed for a clean, plug-n-play, high-powered, easy to install audio upgrade for your 24' Road Glide
Key Features NX652-150 Component Speakers 6.5 inch carbon fiber cone PC injected basket 38mm Ferrofluid cooled voice coil assembly Spider-less suspension design High energy neodymium magnet assembly Bridge mounted, 1 inch inverted dome aluminum tweeter DCM1 Direct Connect Module: 100% Plug and Play to 2024+ factory connector, no battery wires Current sensing power-on detection, no remote wire required Built-in DSP configured for 2024+ factory system 6 Watt Class-D, high level speaker outputs Rear speaker wire connector (high-level output to drive secondary amp) Power/Ground output terminal block for standardized wiring RS400 400 Watt Digital Amplifier: Class-D power amplifier, efficient power, low heat Clean high-power audio without over-taxing charging system Standard interfaces for universal applications Built-in crossovers and pre-filter for complete customization 2oz copper clad gold immersion plated circuit boards Conformal coated to protect against corrosion and moisture AB150-24S Amplifier Bracket: 16-gauge, laser cut steel Powder coated Completely bolt-in with no modifications required All hardware included
Note:This system is not compatible with CVO amplifiers (BLACK)

 DCS4002 Installation Guide [From User Guides]

RS400 Specifications

Input Channels: 2 High/Low Level Output Channels: 2 Channels Nominal Output @ 4 ohms: 200W (100Wx2) Nominal Output @ 2 ohms: 400W (200Wx2) Frequency Response: 10Hz-50kHz Low Level (RCA Line-In) Sensitivity: 200MV - 6V High Level (Speaker-In) Sensitivity: 400MV - 12V Input Impedance: 33K ohms DC Output Offset: +/- 0.01V Enclosure: 4.0"W x 4.5"D x 1.7"H Regulated Class-D Amplifier Sound Quality: 00.005% THD+N @ 90W 4 ohms 00.010% THD+N @ 100W 4 ohms 10.000% THD+N @ 124W 4 ohms Dynamic Range: 103DB Over-Current/Temperature Protection Turn-On/Off Pop Suppression

NX652-150 Specifications

2 ohm, 38mm voice coil
Ferrofluid filled (cooling)
150 Watts RMS, 300 Watts Peak (Rated - 150Watts)
Effective Frequency Range: 50Hz - 22KHz
Sensitivity, SPL: 90dB +/-3dB / 1W @ 1M
2-way passive crossover (affixed)
1.25" bridge-mounted aluminum inverted dome tweeter
6.50" Carbon fiber cone