HUA360 Specifications [From Accessories]
Wired Remote / Steering Wheel Control adapts to:
Sony, Pioneer, Alpine, Kenwood, JVC, Clarion
Battery/Ground Power Handling: +12V @ 10A
Ignition/Ground Power Handling: +12V @ 5A
Illumination/Softswitch Power Hold: +12V @ 500mA
Illumination/Softswitch Power Surge: +12V @ 1.2A
Acceptable wire gauge: 12-30AWG
HSA150 Specifications [From Accessories]
Wired Remote / Steering Wheel Control adapts to:
Sony, Pioneer
Battery/Ground Power Handling: +12V @ 10A
Ignition/Ground Power Handling: +12V @ 5A
Acceptable wire gauge: 12-30AWG
DCS1202 Specifications [From Amplifiers]
Input Channels: 2 High/Low Level
Output Channels: 2 Channels
Nominal Output Impedance: 4 ohms
Nominal Power Output (Watts RMS): 120 Watts (60Wx2)
Frequency Response: 125Hz-50kHz
Low Level (RCA Line-In) Sensitivity: 200MV – 6V
High Level (Speaker-In) Sensitivity: 400MV – 12V
Input Impedance: 33K ohms
DCS1202 Dimensions: 6.50”W x 3.75”D x 1.50”H
Class-T® Amplifier Sound Quality Typically:
00.010% THD+N @ 60W 4 ohms
Over-Current & Over-Temperature Protection
Turn-On & Turn-Off Pop Suppression |
|
Input Channels: 2 High/Low Level
Output Channels: 2 Channels
Nominal Output Impedance: 4 ohms
Nominal Power Output (Watts RMS): 150 Watts (75Wx2)
Frequency Response: 10Hz-50kHz
Low Level (RCA Line-In) Sensitivity: 200MV – 6V
High Level (Speaker-In) Sensitivity: 400MV – 12V
Input Impedance: 33K ohms
PSC1502 Dimensions: 6.50”W x 3.75”D x 1.50”H
Class-T® Amplifier Sound Quality Typically:
00.005% THD+N @ 70W 4 ohms
00.010% THD+N @ 75W 4 ohms
10.000% THD+N @ 117W 4 ohms
Dynamic Range: 103DB
Over-Current & Over-Temperature Protection
Turn-On & Turn-Off Pop Suppression |
|
Input Channels: 4 High/Low Level
Output Channels: 4 Channels, 1 Sub
Nominal Output Impedance: 4 ohms
Nominal Power Output (Watts RMS): 300 Watts (75Wx2, 75Wx4, 60Wx5)
Frequency Response: 10Hz-50kHz
Low Level (RCA Line-In) Sensitivity: 200MV – 6V
High Level (Speaker-In) Sensitivity: 400MV – 12V
Input Impedance: 33K ohms
PSC3004 Dimensions: 6.50”W x 3.75”D x 1.50”H
Class-T® Amplifier Sound Quality Typically:
00.005% THD+N @ 70W 4 ohms
00.010% THD+N @ 75W 4 ohms
10.000% THD+N @ 117W 4 ohms
Dynamic Range: 103DB
Over-Current & Over-Temperature Protection
Turn-On & Turn-Off Pop Suppression |
|
Input Channels: 4 High/Low Level
Output Channels: 4 Channels, 1 Sub
Nominal Output Impedance: 4 ohms
Nominal Power Output (Watts RMS): 300 Watts (75Wx2, 75Wx4, 60Wx5)
Frequency Response: 10Hz-50kHz
Low Level (RCA Line-In) Sensitivity: 200MV – 6V
High Level (Speaker-In) Sensitivity: 400MV – 12V
Input Impedance: 33K ohms
PSC3004 Dimensions: 6.50”W x 3.75”D x 1.50”H
PSA75 Dimensions: 2.75”W x 3.00”D x 1.30”H
Class-T® Amplifier Sound Quality Typically:
00.005% THD+N @ 70W 4 ohms
00.010% THD+N @ 75W 4 ohms
10.000% THD+N @ 117W 4 ohms
Dynamic Range: 103DB
Over-Current & Over-Temperature Protection
Turn-On & Turn-Off Pop Suppression |
|
Input Channels: 1 Satellite Control
Output Channels: 1 Channel
Nominal Output Impedance: 4 ohms
Nominal Power Output (Watts RMS): 75 Watts (75 Watts x1)
PSA75 Dimensions: 2.75”W x 3.00”D x 1.30”H
Class-T® Amplifier Sound Quality Typically:
00.005% THD+N @ 70W 4 ohms
00.010% THD+N @ 75W 4 ohms
10.000% THD+N @ 117W 4 ohms
Dynamic Range: 103DB
Over-Current & Over-Temperature Protection
Turn-On & Turn-Off Pop Suppression |
|
Input Channels: 1 Satellite Control
Output Channels: 1 Channel
Nominal Output Impedance: 4 ohms
Nominal Power Output (Watts RMS): 75 Watts (75 Watts x1)
PSA75 Dimensions: 2.75”W x 3.00”D x 1.30”H
Class-T® Amplifier Sound Quality Typically:
00.005% THD+N @ 70W 4 ohms
00.010% THD+N @ 75W 4 ohms
10.000% THD+N @ 117W 4 ohms
Dynamic Range: 103DB
Over-Current & Over-Temperature Protection
Turn-On & Turn-Off Pop Suppression |
|
8 ohm, 25mm voice coil
40 Watts RMS, 120 Watts Peak (Rated - 40 Watts)
1" PEI dome coax-mounted tweeter
5.25" polypropylene mid-range cone
8 oz. magnet with rubber cover
BT504-50C Specifications [From Speakers]
4 ohm, 25mm voice coil
50 Watts RMS, 150 Watts Peak (Rated - 50 Watts)
1" PEI dome coax-mounted tweeter
5.25" polypropylene mid-range cone
8 oz. magnet with rubber cover
RX502-50 Specifications [From Speakers]
2 ohm, 20mm voice coil
50 Watts RMS, 100 Watts Peak (Rated - 50 Watts)
Effective Frequency Range: 60Hz - 20KHz
Sensitivity, SPL: 90dB +/-3dB / 1W @ 1M
1" PEI dome coax-mounted tweeter
5.25" polypropylene mid-range cone
Lightweight neodymium magnet with heat sink
RX508-50 Specifications [From Speakers]
8 ohm, 20mm voice coil
50 Watts RMS, 100 Watts Peak (Rated - 50 Watts)
Effective Frequency Range: 60Hz - 20KHz
Sensitivity, SPL: 90dB +/-3dB / 1W @ 1M
1" PEI dome coax-mounted tweeter
5.25" polypropylene mid-range cone
Lightweight neodymium magnet with heat sink
RX504-50 Specifications [From Speakers]
4 ohm, 20mm voice coil
50 Watts RMS, 100 Watts Peak (Rated - 50 Watts)
Effective Frequency Range: 60Hz - 20KHz
Sensitivity, SPL: 90dB +/-3dB / 1W @ 1M
1" PEI dome coax-mounted tweeter
5.25" polypropylene mid-range cone
Lightweight neodymium magnet with heat sink
SX502-60 Specifications [From Speakers]
2 ohm, 25mm voice coil
60 Watts RMS, 150 Watts Peak (Rated - 60 Watts)
Effective Frequency Range: 65Hz - 20KHz
Sensitivity, SPL: 90dB +/-3dB / 1W @ 1M
1.25" bridge-mounted component tweeter
5.25" solid polypropylene cone
10 oz. magnet with rubber boot
SX508-60 Specifications [From Speakers]
8 ohm, 25mm voice coil
60 Watts RMS, 150 Watts Peak (Rated - 60 Watts)
Effective Frequency Range: 65Hz - 20KHz
Sensitivity, SPL: 90dB +/-3dB / 1W @ 1M
1.25" bridge-mounted component tweeter
5.25" solid polypropylene cone
10 oz. magnet with rubber boot
SX504-60 Specifications [From Speakers]
4 ohm, 25mm voice coil
60 Watts RMS, 150 Watts Peak (Rated - 60 Watts)
Effective Frequency Range: 65Hz - 20KHz
Sensitivity, SPL: 90dB +/-3dB / 1W @ 1M
1.25" bridge-mounted component tweeter
5.25" solid polypropylene cone
10 oz. magnet with rubber boot
DX504-70 Specifications [From Speakers]
4 ohm, 25mm voice coil
70 Watts RMS, 200 Watts Peak (Rated - 70 Watts)
Effective Frequency Range: 60Hz - 20KHz
Sensitivity, SPL: 90dB +/-3dB / 1W @ 1M
2-way passive crossover (12 dB/octave)
1.25" bridge-mounted component tweeter
5.25" solid polypropylene cone
12 oz. magnet with rubber boot
STK100 Specifications [From Tweeter Kits]
12 db/octave Crossover
50 Watts RMS, 100 Watts Peak (Rated - 50 Watts)
Sensitivity, SPL: 93dB +/-2dB / 1W @ 1M
Magnet, 28mm x 8.5mm NEO
